RAM 2500 Truck 2WD L6-5.9L DSL Turbo (2008)
![background image](/dodge/ram_2500_2wd/l6-5.9l_dsl_turbo/Page-3537001.png)
Oil Pressure Sender: Service and Repair
Engine Oil Pressure Sensor/Switch - Installation
INSTALLATION
1. If the switch is not being replaced, replace and lubricate the o-ring.
2. Install the oil pressure switch and tighten to 18 Nm (159 in. lbs.) torque.
3. Connect oil pressure switch connector.
4. Connect the battery negative cables.
5. Start engine and check for oil leaks at the switch.