RAM 2500 Truck 2WD L6-5.9L DSL Turbo VIN 7 (2001)
7. Install the cover to the gear housing, aligning the seal pilot with the nose of the crankshaft (Fig. 107).
8. Install the cover bolts and tighten to 24 Nm (18 ft. lbs.) torque. Remove pilot tool.
9. Install the crankshaft damper (Fig. 104) and torque the bolts to 125 Nm (92 ft. lbs.). Use the engine barring tool to keep the engine from rotating
during tightening operation.
10. Install the fan support/hub assembly (Fig. 103) and torque bolts to 24 Nm (18 ft. lbs.).
11. Install cooling fan.
12. Install the accessory drive belt.
13. Refill cooling system.
14. Connect battery negative cables.
15. Start engine and check for oil leaks.