RAM 2500 Truck 2WD L6-5.9L DSL Turbo VIN 7 (2001)
Fig. 45 Intake Manifold Air Heater (Elements)
12. Remove intake manifold air heater element block from engine (Fig. 45). Discard old upper and lower gaskets
13. Remove 3 cable bracket housing mounting bolts (Fig. 44). Carefully position cable bracket and cable assembly to side of engine. Leave cables
connected to lever.
Fig. 46 High-Pressure Fuel Lines
14. Remove engine lifting bracket at rear of intake manifold (2 bolts) (Fig. 46).
15. Remove bolts from all fuel injection line support brackets at intake manifold.
16. Place shop towels around fuel lines at fuel injectors. Do not allow fuel to drip down side of engine.
CAUTION: WHEN LOOSENING OR TIGHTENING HIGH-PRESSURE FITTINGS AT INJECTION PUMP, USE A BACK-UP WRENCH
ON DELIVERY VALVE AT PUMP. DO NOT ALLOW DELIVERY VALVE TO ROTATE.
