RAM 2500 Truck 2WD L6-5.9L DSL Turbo VIN 7 (2001)
Camshaft Position Sensor: Service and Repair
REMOVAL
Fig.9 CMP Location
The camshaft position sensor (CMP) is located below the fuel injection pump. It is attached to the back of the timing gear cover housing.
1. Disconnect both negative cables from both batteries.
2. Clean area around CMP.
3. Disconnect electrical at CMP.
Fig.10 CMP R/I - Diesel
4. Remove CMP mounting bolt. Bolt head is female-hex.
5. Remove CMP from engine by twisting and pulling straight back.
6. Discard CMP O-ring.
INSTALLATION