RAM 2500 Truck 2WD L6-5.9L DSL Turbo VIN 7 (2001)
Ignition Off-Draw (IOD) Fuse: Service and Repair
REMOVAL
The Ignition-Off Draw (IOD) fuse is disconnected from Junction Block (JB) fuse cavity 12 when the vehicle is shipped from the assembly plant.
Dealer personnel must reconnect the IOD fuse when the vehicle is being prepared for delivery in order to restore full electrical system operation.
1. Turn the ignition switch to the OFF position.
2. Remove the fuse access panel by unsnapping it from the left outboard end of the instrument panel.
3. Grasp the upper and lower tabs of the IOD fuse holder unit in fuse cavity 12 of the JB between the thumb and forefinger and pull the unit firmly
outward.
4. Install the fuse access panel by snapping it onto the left outboard end of the instrument panel.
Fig.4 Ignition-Off Draw Fuse
INSTALLATION
The Ignition-Off Draw (IOD) fuse is disconnected from Junction Block (JB) fuse cavity 12 (Fig. 4) when the vehicle is shipped from the assembly
plant. Dealer personnel must reconnect the IOD fuse when the vehicle is being prepared for delivery in order to restore full electrical system operation.
1. Turn the ignition switch to the OFF position.
2. To install the IOD fuse, use a thumb to press the IOD fuse holder unit in fuse cavity 12 firmly into the JB.
3. Install the fuse access panel by snapping it onto the left outboard end of the instrument panel.