RAM 2500 Truck 2WD L6-6.7L DSL Turbo (2010)
![background image](/dodge/ram_2500_2wd/l6-6.7l_dsl_turbo/Page-1352005.png)
6. Position the connector locking finger away from the terminal using the proper special tool. Pull on the wire to remove the terminal from the
connector.
Installation
TERMINAL INSTALLATION
1. Select a wire from the terminal repair kit that best matches the color and gage of the wire being repaired.
2. Cut the repair wire to the proper length and remove one-half (1/2) inch of insulation.
3. Splice the repair wire to the wire harness (see wire splicing procedure) . See: Service Procedures/Wire Splicing
4. Insert the repaired wire into the connector.
5. Install the connector locking wedge, if required, and reconnect the connector to its mating half/component.
6. Re-tape the wire harness starting at 1-1/2 inches behind the connector and 2 inches past the repair.