dodge Workshop Repair Guides

Dodge Workshop Service and Repair Manuals

Compass/Trip Computer - Indicates False MPG|Page 6714 > < Compass/Trip Computer - Indicates False MPG
Page 2
background image

PARTS REQUIRED:

AR (1)

55350660AE

Computer, Compass Mini Trip, Without Vehicle Theft Alarm

AR (1)

55350003AE

Computer, Compass Mini Trip, With Vehicle Theft Alarm

POLICY: Reimbursable within the provisions of the warranty.

TIME ALLOWANCE:

Labor Operation No:

08-50-20-92

0.5 Hrs.

FAILURE CODE: P8 - New Part

Repair Procedure

This bulletin involves installing a revised compass mini trip computer.

1.

Disconnect and isolate the battery negative cable. On diesel equipped vehicles, both negative cables must be disconnected and isolated.

2.

Open the garage door opener storage bin door and locate the two overhead console latch tabs near the front of the bin (Figure 2).

3.

While pulling gently downward on the front of the overhead console, push the latch tabs forward until each latch is disengaged from its receptacle
in the inner roof panel.

NOTE:

THE LATCH TABS MAY BE DIFFICULT TO DEPRESS COMPLETELY ENOUGH TO RELEASE THE OVERHEAD CONSOLE. ENSURE
THAT THE LATCH TABS HAVE RELEASED THE OVERHEAD CONSOLE COMPLETELY BEFORE PULLING THE CONSOLE
DOWNWARD AWAY FROM THE ROOF PANEL.

4.

Slide the overhead console rearward far enough to disengage the two mounting hooks on the rear of the housing from the mounting holes in the
inner roof panel.

5.

Lower the overhead console from the headliner far enough to access the wire harness connector then, disconnect the connector and separate the
overhead console from the vehicle.

6.

Remove the three screws that secure the compass mini trip computer to the overhead console housing (Figure 3).

Compass/Trip Computer - Indicates False MPG|Page 6714 > < Compass/Trip Computer - Indicates False MPG