RAM 2500 Truck 2WD V10-8.0L VIN W MDC (1999)
Power Mirror Switch: Service and Repair
REMOVAL
1. Disconnect and isolate the battery negative cable.
Power Mirror Switch Remove/Install - Typical
2. Pull the control knob rearward to remove it from the power mirror switch stem.
3. Remove the nut that secures the power mirror switch to the driver side front door trim panel.
4. Remove the trim panel from the inside of the driver side front door.
5. Pull the trim panel away from the inner door far enough to access the power mirror switch wire harness connector.
6. Unplug the power mirror switch wire harness connector.
7. Remove the power mirror switch from the back of the door trim panel.
8. Reverse the removal procedures to install.
