RAM 2500 Truck 2WD V8-5.7L (2008)
Cruise Control Switch: Service and Repair
Removal
REMOVAL
Depending on engine control computer (JTEC having a 3-plug connector or 5.7L V-8 NGC having a 4-plug connector), 2 types of switches are
used. Both types of switches are internally and externally different. The switches used with the NGC system have attached pigtail leads. The
switch used with the JTEC system does not have an attached pigtail lead.
1. Remove switch mounting screw (2).
2. Pull switch (2) from steering wheel.
3. Unplug electrical connector from switch, or, if equipped, switch pigtail wire harness from steering wheel wire harness (4) and remove switch.
