RAM 2500 Truck 2WD V8-5.7L VIN D (2004)
Underhood Light Bulb: Service and Repair
REMOVAL
1. Disconnect and isolate the battery negative cable.
2. Insert a small flat blade in the access slot between the lamp base and lamp lens.
3. Pry the lamp lens upward and remove the lamp lens.
4. Depress the bulb terminal inward to release the bulb.
INSTALLATION
1. Engage the replacement bulb wire loop to the terminal closest to the lamp base wire connector.
2. Depress the opposite terminal inward and engage the remaining bulb wire loop.
3. Position the lamp lens on the lamp base and press into place.
4. Connect the battery negative cable.
