RAM 2500 Truck 2WD V8-5.7L VIN D (2004)
Wiper Relay: Service and Repair
Wiper on/Off Relay Replacement
WIPER ON/OFF RELAY
REMOVAL
1. Disconnect and isolate the battery negative cable.
Fig.29 Integrated Power Module
2. Remove the cover from the Integrated Power Module (IPM).
3. Remove the wiper on/off relay by grasping it firmly and pulling it straight out from the receptacle in the IPM.
INSTALLATION
1. Position the wiper on/off relay to the proper receptacle in the Integrated Power Module (IPM).
2. Align the wiper on/off relay terminals with the terminal cavities in the IPM receptacle.
3. Push firmly and evenly on the top of the wiper on/off relay until the terminals are fully seated in the terminal cavities in the IPM receptacle.
4. Reinstall the cover onto the IPM.
5. Reconnect the battery negative cable.