RAM 2500 Truck 2WD V8-5.9L VIN Z (1997)
Power Seat Switch: Service and Repair
REMOVAL
1. Disconnect and isolate the battery negative cable.
Seat Switch and Bezel Remove/Install
2. Remove the two screws that secure the switch and bezel unit to the seat cushion frame.
Power Seat Switch Connector Remove
3. Pull the switch and bezel unit out from the seat far enough to access the switch wire harness connector. Gently pry the locking tabs of the switches
away from the wire harness connector and carefully unplug the connector from the switch body.
4. Remove the two screws that secure the switch to the bezel and remove the bezel.
5. Reverse the removal procedures to install.
