RAM 2500 Truck 4WD L6-359 5.9L DSL Turbo VIN D FI (1998)
Fig 66 Water In Fuel Sensor
If filter canister is not filled with clean diesel fuel before installation, manual air bleeding of the fuel system may be necessary (temporary
rough engine running may occur). If necessary, refer to the Air Bleed Procedure.
6. Fill filter canister with clean diesel fuel.
7. Apply a light film of clean diesel oil to seals.
8. Position canister assembly to canister header.
-
Note that the locating tabs on canister should align into header tab on canister header.
-
This step must be followed to prevent damage to canister or header and to prevent contact of drain valve into throttle linkage.
9. Install canister nut and tighten to 14 N.m (10 ft. lbs.) torque.
10. Connect electrical connector to WIF sensor.
11. Connect drain hose to bottom of drain valve.
12. Start engine and check for leaks.