RAM 2500 Truck 4WD L6-359 5.9L DSL Turbo VIN D FI (1998)
15. Disconnect engine oil supply line at side of pump.
16. Remove oil fill tube bracket mounting bolt.
17. Remove oil fill tube from tube-to-gear housing adapter. Tube is removed by screwing counterclockwise from adapter.
18. Remove oil fill tube adapter from gear housing. Adapter is removed by screwing counterclockwise from gear housing.
19. The engine is equipped with a built-in moveable timing pin. This pin is located above power steering pump, below and to inside of fuel injection
pump, on rear of cam gear housing. The pin will engage into a machined hole in the back of camshaft gear. It is designed to position engine to
TDC (Top Dead Center) on compression stroke of number 1 cylinder.