RAM 2500 Truck 4WD L6-5.9L DSL Turbo VIN 6 (1999)
Inspecting Push Rod For Flatness
Roll the push rod on a flat work surface with the socket end hanging off the edge. Replace any push rod that appears to be bent.
Crossheads
Inspecting Crosshead For Cracks
Inspect the crossheads for cracks and/or excessive wear on rocker lever and valve tip mating surfaces.
INSTALLATION
1. If previously removed, install the push rods in their original location. Verify that they are seated in the tappets.
2. Lubricate the valve tips and install the crossheads in their original locations.
3. Lubricate the crossheads and push rod sockets and install the rocker arms and pedestals their original locations. Tighten bolts to 36 Nm (27 ft.
lbs.) torque.
4. Verify valve lash adjustment.
5. Install cylinder head cover and reusable gasket. Torque bolts to 24 Nm (18 ft. lbs.).
6. Connect battery negative cables.
