RAM 2500 Truck 4WD L6-5.9L DSL Turbo VIN 6 (1999)
Valve Body: Service and Repair
Disassembly and Assembly
Disassembly
CAUTION: Do not clamp any valve body component in a vise. This practice can damage the component resulting in unsatisfactory operation after
assembly and installation. Do not use pliers to remove any of the valves, plugs or springs and do not force any of the components out or into place.
The valves and valve body housings will be damaged if force is used. Tag or mark the valve body springs for reference as they are removed. Do not
allow them to become intermixed.
1. Remove fluid filter.
Fig. 39
2. Disconnect wires from governor pressure sensor and solenoid (Fig. 39).
Fig. 40
3. Remove screws attaching governor body and retainer plate to transfer plate (Fig. 40).
