RAM 2500 Truck 4WD L6-5.9L DSL Turbo VIN 6 (1999)
1
CH6OOO
Scan Tool (DRB III)
1
CH7000/7001
J1962 Cable
REPAIR PROCEDURE:
1.
Inspect the new separator plate (p/n 52118048AD). The revised plate will have additional material removed (see hash marks in Figure 1) creating
a wider slot (0.470 inch) to allow for increased fluid flow to the torque converter clutch.
2.
Clean the separator plate to remove any dirt or rust inhibitor prior to installation.
3.
Replace the transmission valve body upper housing separator plate and the transmission oil pan gasket (p/n 02464324AB). Refer to the
appropriate year Service Manual, Section 21 - Transmission and Transfer Case for removal and installation instructions of the transmission valve
body and its upper housing separator plate.
4.
Verify fluid level after warming up the transmission and cycling the shift lever several times.
5.
Verify, and if required, adjust the transmission shift linkage and the transmission throttle valve cable per the appropriate Service Manual
procedures.
POLICY: Reimbursable within the provisions of the warranty.
TIME ALLOWANCE:
Labor Operation No: 21-95-01-92 1.6 Hrs.
FAILURE CODE: P8- New Part
