RAM 2500 Truck 4WD L6-5.9L DSL Turbo VIN 6 (1999)
Windshield Washer Reservoir: Service and Repair
REMOVAL
1. Disconnect and isolate the battery negative cable.
2. Drain the engine cooling system and remove the upper hose from the radiator.
3. Unplug the wire harness connectors from the washer pump and, if the vehicle is so equipped, the washer fluid level sensor.
4. Remove the washer supply hose from the washer pump and drain the washer fluid from the reservoir into a clean container for reuse.
Washer Reservoir And Pump Remove/Install
5. While pulling the reservoir away from the fan shroud, lift the reservoir upwards far enough to disengage the reservoir mounting tabs from the
upper and lower mounting slots in the fan shroud.
6. Remove the reservoir from the engine compartment.
7. Reverse the removal procedures to install.