RAM 2500 Truck 4WD L6-5.9L DSL Turbo VIN 7 (2001)
Trip Computer: Service and Repair
REMOVAL
1. Disconnect and isolate the battery negative cable.
2. Remove the overhead console from the headliner. Refer to Overhead Console in the Removal and Installation for the procedures.
Compass Mini-Trip Computer Remove/Install
3. Remove the three screws that secure the Compass/Mini-Trip Computer module to the overhead console housing.
4. Pull the Compass/Mini-Trip Computer module away from the overhead console far enough to access the wire harness connector.
5. Disconnect the overhead console wire harness connector from the Compass/Mini-Trip Computer module connector receptacle.
6. Remove the Compass/Mini-Trip Computer module from the overhead console housing.
INSTALLATION
1. Position the Compass/Mini-Trip Computer module onto the overhead console housing.
2. Reconnect the overhead console wire harness connector to the Compass/Mini-Trip Computer module connector receptacle.
3. Install and tighten the three screws that secure the Compass/Mini-Trip Computer module to the overhead console housing. Tighten the screws to
2.2 Nm (20 in. lbs.).
4. Install the overhead console onto the headliner. Refer to Overhead Console in the Removal and Installation for the procedures.
5. Reconnect the battery negative cable.
NOTE: If a new Compass/Mini-Trip Computer has been installed, the compass will have to be calibrated and the variance set. Refer to Compass
Variation Adjustment and Compass Calibration