RAM 2500 Truck 4WD L6-5.9L DSL Turbo VIN 7 (2001)
Audible Warning Device Control Module: Service and Repair
REMOVAL
WARNING: ON VEHICLES EQUIPPED WITH AIRBAGS, DISABLE THE AIRBAG SYSTEM BEFORE ATTEMPTING ANY
STEERING WHEEL, STEERING COLUMN, OR INSTRUMENT PANEL COMPONENT DIAGNOSIS OR SERVICE. DISCONNECT
AND ISOLATE THE BATTERY NEGATIVE (GROUND) CABLE, THEN WAIT TWO MINUTES FOR THE AIRBAG SYSTEM
CAPACITOR TO DISCHARGE BEFORE PERFORMING FURTHER DIAGNOSIS OR SERVICE. THIS IS THE ONLY SURE WAY TO
DISABLE THE AIRBAG SYSTEM. FAILURE TO TAKE THE PROPER PRECAUTIONS COULD RESULT IN ACCIDENTAL AIRBAG
DEPLOYMENT AND POSSIBLE PERSONAL INJURY.
NOTE: Before replacing a high-line/premium version Central Timer Module (CTM), use a DRB III scan tool to retrieve the current settings for the
CTM programmable features. Refer to the appropriate diagnostic information. These settings should be duplicated in the replacement
high-line/premium CTM using the DRB III scan tool before returning the vehicle to service.
1. Disconnect and isolate the battery negative cable.
2. Remove the steering column opening cover from the instrument panel.
Fig.3 Central Timer Module (Base) Remove/Install
