RAM 2500 Truck 4WD L6-6.7L DSL Turbo VIN A (2007)
Body Emblem: Service and Repair
Removal
REMOVAL
NAME PLATES
NOTE: Mega Cab model shown in the illustration. Exterior name plates and decals for all other cab models are similar. Exterior name plate
and decal usage vary by model.
1. As a guide for installation, apply a length of masking tape on the body (1), parallel to the top edge and, to one end of the name plate or decal (2)
being removed.
CAUTION: Do not exceed 52° C (120° F) when heating name plates, decals or body panels. Failure to follow this caution may result in damage
to the name plates, decals and/or the vehicle paint finish.
2. If the temperature is below 21° C (70° F), warm the name plate or decal with a heat lamp or heat gun.
NOTE: The exterior name plates are attached to the body with adhesive tape.
3. Using a trim stick C-4755 or equivalent, carefully remove the name plate or decal from the body panel, as necessary.