RAM 2500 Truck 4WD V10-8.0L VIN W (1997)
Control Assembly: Service and Repair
Fig 33 Heater A/C Control And Message Center Removal/Installation
REMOVAL
1. Disconnect and isolate the battery negative cable.
2. Remove the instrument cluster bezel. Refer to Instrument Panel Systems for the procedures.
3. Remove the four screws that secure the message center/heater-A/C control to the instrument panel.
4. Pull the message center and heater-A/C control assembly away from the instrument panel far enough to access the wire harness connectors.
Fig 34 Message Center And Heater-A/C Control Connectors
5. Unplug the two wire harness connectors from the rear of the message center and heater-A/C control assembly.
