RAM 2500 Truck 4WD V10-8.0L VIN W HDC (2000)
Controller Antilock Brake: Service and Repair
Rear Wheel Antilock System
NOTE: If the CAB needs to be replaced, the rear axle type and tire revolutions per mile must be programmed into the new CAB. For axle type refer to
Transmission and Drivetrain, Differential. For tire revolutions per mile refer to Steering and Suspension, Tires, Wheels and Alignment. To program the
CAB refer to Testing and Inspection, Procedures.
REMOVAL
1. Pull up on the CAB harness connector lock release and remove the connector from the controller.
2. Remove the RWAL valve harness connector from the controller.
3. Remove the controller mounting screws and remove the controller from the mounting bracket.
INSTALLATION
1. Position the controller on the bracket and install the mounting screws. Tighten the screws to 2.5 - 3.5 Nm (22 - 31 inch lbs.).
2. Install the RWAL valve harness connector into the controller.
3. Install the CAB harness connector into the controller and push down on the connector lock.
