RAM 2500 Truck 4WD V8-57L VIN D (2005) Rear Door Panel Service and Repair
1. Remove the interior door handle actuator.
2. Remove the speaker.
CAUTION: Do not allow the waterdam adhesive to become contaminated with dirt or other foreign substances. If the waterdam becomes
contaminated or damaged, replace it.
3. Carefully remove the waterdam (1) from around the perimeter of the rear door (2).
4. Separate the waterdam from the interior handle actuator rod and the door wire harness (if equipped) and remove the waterdam.
INSTALLATION
CAUTION: Do not allow the waterdam or adhesive to become contaminated with dirt or other foreign substances. If the waterdam becomes
contaminated or damaged, replace it.
NOTE: Be sure that the waterdam is fully sealed around the perimeter of the door.
1. Position the interior handle actuator rod and the wire harness (if equipped) through the holes in the waterdam (1) and install the waterdam to the
door (2).
2. Install the speaker.
3. Install the interior door handle actuator.
