RAM 2500 Truck 4WD V8-5.7L VIN D (2005)
1. Clean cylinder head cover (1) and both sealing surfaces (1,4,). Inspect and replace gasket (2) as necessary.
2. Install cylinder head cover and hand start all fasteners. Verify that all double ended studs are in the correct location and install left and right
ground straps.
CAUTION: The ground straps must be installed in the same location as removed. The covers are machined to accept the ground straps in those
locations only.
NOTE: The right hand ground strap is located on the front inboard stud. The left hand ground strap is located on the rear inboard stud.
