RAM 2500 Truck 4WD V8-5.7L VIN D (2005)
2. Remove the tape or plugs from the opened ends of the A/C liquid lines and the evaporator inlet tube (6).
3. Lubricate a new seal with clean refrigerant oil and install it on the rear liquid line spring-lock coupler fitting. Use only the specified seal as it is
made of a special material for the R-134a system. Use only refrigerant oil of the type recommended for the A/C compressor in the vehicle.
4. Connect the rear section of the A/C liquid line to the evaporator inlet tube.
5. Install the secondary retaining clip (5) onto the spring-lock coupler that secures the rear section of the A/C liquid line onto the evaporator inlet
tube.
6. Engage the A/C liquid line into the body retaining clip (3).
7. Lubricate a new seal with clean refrigerant oil and install it on the front liquid line spring-lock coupler fitting. Use only the specified seal as it is
made of a special material for the R-134a system. Use only refrigerant oil of the type recommended for the A/C compressor in the vehicle.
8. Connect the rear section of the A/C liquid line to the front section of the liquid line (10).
9. Install the secondary retaining clip (2) onto the spring-lock coupler that secures the front section of the A/C liquid line to the rear section of the
liquid line.
10. If equipped with a gasoline engine, install the air filter housing.
11. If equipped with the diesel engine, install the passenger side battery tray.
12. Reconnect the negative battery cable(s).
13. Evacuate the refrigerant system.
14. Charge the refrigerant system.
