RAM 2500 Truck 4WD V8-5.7L VIN D (2005)
4. Position the lower shroud (3) onto the steering column (4).
5. From below the steering column, install and tighten the one center screw that secures the lower shroud to the steering column. Tighten the screw to
2 N.m (20 in.lbs.)
6. Position the upper shroud (1) onto the steering column over the lower shroud. On vehicles equipped with an automatic transmission, be certain to
engage the gearshift lever gap hider into the opening in the right side of both shroud halves.
7. Align the snap features on the upper shroud with the receptacles in the lower shroud and apply hand pressure to snap them together.
8. Install and tighten the two outboard screws that secure the upper shroud to the lower shroud. Tighten the screws to 2 N.m (20 in.lbs.)
9. Align the tilt steering column knob (2) with the tilt adjuster lever (1) on the left side of the steering column and use hand pressure to snap it back
into place.
10. Reconnect the battery negative cable.
NOTE: If the SKIM is replaced with a new unit, a diagnostic scan tool MUST be used to initialize the new SKIM and to program at least two
Sentry Key transponders before the vehicle can be operated.