RAM 2500 Truck 4WD V8-5.7L VIN D (2005)
Rear Defogger Relay: Service and Repair
NOTE: Refer to the fuse and relay layout map on the inside of the IPM cover for EBL relay location.
REMOVAL
1. Disconnect and isolate the negative battery cable (1).
2. Remove the cover from the integrated power module (IPM) (2) located in the engine compartment.
3. Remove the EBL relay from the IPM.
INSTALLATION
1. Position the EBL relay into the proper receptacle of the integrated power module (IPM) (2).
2. Align the EBL relay terminals with the terminal cavities in the IPM receptacle and push down firmly on the relay until the terminals are fully
seated.
3. Install the cover onto the IPM.
4. Reconnect the negative battery cable (1).