RAM 2500 Truck 4WD V8-5.7L VIN D (2005)
2. Install the oil seal with special tool 8989 driver (2) and C-4171 handle (1).
3. Install backup washer.
4. Install the retainer ring with snap ring pliers.
5. Coat the dust seal with high temp grease.
6. Install the dust seal with a driver (2) and handle (1).
7. Install protective seal protector 8993 (2) over the shaft (1).
8. Install the pitman shaft into the steering gear until it fully seats into the bearing.
9. Install the new cover bolts and tighten to 68 Nm (50 ft. lbs.).
10. Install the pitman arm.