RAM 2500 Truck 4WD V8-5.7L VIN D (2005)
1. Remove the front propeller shaft.
2. Install two bolts 180°apart into the front output shaft companion flange.
3. Place Holder 6719 (1) over the bolts (2) and against the companion flange.
4. Remove and discard the front companion flange nut.
5. Remove the companion flange from the front output shaft. It may be necessary to use Flange puller 8992 to remove the companion flange.
6. Using a screw and a slide hammer, remove the front output shaft seal.
INSTALLATION
1. Install the new front output shaft seal with Installer MB991168A.
2. Install the front companion flange onto the front output shaft.
3. Install two bolts 180°apart into the front output shaft companion flange.
4. Place Holder 6719 (1) over the bolts (2) and against the companion flange.
5. Install a new front companion flange nut. Tighten the companion flange nut to 258-312 Nm (190-230 ft. lbs.).
6. Install front propeller shaft.
