RAM 2500 Van V8-318 5.2L VIN T Magnum CNG SFI (1997)
Power Door Lock Control Module: Service and Repair
REMOVAL
1. Disconnect and isolate the battery negative cable.
Instrument Cluster Bezel Remove/Install
2. Remove the six screws that secure the instrument cluster bezel to the instrument panel.
3. Pull the bezel off of the upper retaining clips.
Radio Remove/Install
4. Remove the two radio mounting screws.
5. Remove the screw that secures the radio ground strap to the instrument panel above the radio.
6. Pull the radio out from the instrument panel far enough to unplug the wire harness connectors and the antenna coaxial cable connector. If equipped
with the Infinity speaker option, also unplug the wire harness connector from the ground terminal on the back of the radio chassis.
7. Remove the radio from the instrument panel.
