RAM 2500 Van V8-318 5.2L VIN T Magnum CNG SFI (1997)
Electronic Brake Control Module: Service and Repair
Four Wheel Antilock Brake System
REMOVAL
1. Disconnect the negative battery cable.
2. Remove the windshield washer and engine coolant recovery reservoirs.
CAB Harness Connector Locking Handle
CAB Harness Connector
3. Disconnect the Controller Antilock Brake (CAB) harness connector by pulling up on the connector release handle.
4. Remove upper and lower mounting bolts.
5. Remove controller from vehicle.
INSTALLATION
1. Install controller into mounting bracket.
2. Install upper and lower mounting bolts.
3. Install harness connector and pull down on locking handle to lock in place.
4. Install the windshield washer and engine coolant recovery reservoirs.
5. Connect the negative battery cable.