RAM 2500 Van V8-318 5.2L VIN T Magnum CNG SFI (1997)
(Figure 1). Set the trim shield aside.
3.
Remove the power seat wiring harness connector from the front riser crossmember and then disconnect the connector (if equipped) (Figure 2).
4.
Disconnect the seat belt switch wiring connector.
5.
Remove the nuts that attach the driver's seat riser to the floor pan (Figure 2).
NOTE:
On some van conversion seating configurations, it may be necessary to separate the seat from the seat riser to remove the riser-to-floor pan
nuts.
6.
Remove the driver's seat assembly from the vehicle.
7.
Remove the four screws that secure the airbag electronic control module (AECM) cover to the AECM. Remove and discard the AECM cover
(Figure 3).
8.
Disconnect the two (2) AECM wiring connectors
9.
Remove the four (4) screws that attach the AECM to the floor pan mounting bracket (Figure 3). Discard the screws.
10.
Remove the AECM. Note the AECM part number for later use and then destroy the old AECM connector pins. Discard the old A£CM.
