RAM 2500 Van V8-318 5.2L VIN T Magnum CNG SFI (1997)
One Jumper Wire Between Terminal P2 And L And P1 And B+
1. Unplug the wire harness connector at the motor. Connect a jumper wire from terminal P2 to terminal L of the wiper motor.
2. Connect a second jumper wire from terminal P1 to the battery. If the motor runs to the park position and stops, the multi-function switch is
faulty. If the motor keeps running and does not park, replace the faulty motor assembly
Condition
The wiper motor will stop when the wiper/ washer switch is set in the Off position, but the wipers do not continue running to the park position.
Procedure
1. Unplug the motor wire harness connector and clean the terminals. Plug in the wire harness connector and test the motor. If not OK, go to Step
2.
2. Set the wiper/washer switch in the Off position. Unplug the motor wire harness connector. Connect a voltmeter or test lamp to the motor
ground strap. Connect the other lead to terminal P1 of the wire harness connector. If voltage is not present, check for an open circuit in the
wire harness or the multi-function switch. If voltage is present, go to Step 3.
Ohmmeter Between Terminal L And P2
3. Connect an ohmmeter or continuity tester between motor terminals L and P2. If there is continuity between these terminals, the problem is a
faulty motor. If there is no continuity, the problem is an open in the wire harness or a faulty multi-function switch.
