RAM 2500 Van V8-360 5.9L Magnum (1995)
7. Insert special fuel line removal tool into the fuel line. Use this tool to release the locking fingers in the end of the line.
8. With the special tool still inserted, pull the fuel line from the fuel rail. After disconnection, the locking fingers will remain within the
quick-connect fitting at the end of the fuel line.
9. Inspect fuel line fitting, locking fingers, and fuel rail for damage. Replace as necessary.
10. Prior to connecting the fuel line to the fuel rail, check condition of both fittings. Clean the parts with a lint-free cloth. Lubricate them with clean
engine oil.
11. Insert the fuel line into the fuel rail until a click is felt.
12. Verify a locked condition by firmly pulling on the fuel line and fittings (15-30 lbs).
13. Install latch clip (snaps into position). If the latch clip does not fit, this indicates the fuel line is not properly installed to the fuel rail. Recheck the
fuel line connection.
14. Connect negative battery cable to battery.
15. Start engine and check for leaks.