dodge Workshop Repair Guides

Dodge Workshop Manuals

< PREV PAGE NEXT PAGE >
Page 1
background image

Starter Relay: Testing and Inspection

Fig 3 Starter Relay Terminal Identification

1. Remove starter relay from relay center.
2. Check resistance between ground and ignition terminals. Resistance value between ground and ignition terminals should be 70-80 ohms for

resistor relays and 81-91 ohms for diode relays.

3. Apply battery voltage to relay ignition terminal and connect ground terminal to ground. Continuity should exist between battery and solenoid

terminals. If continuity does not exist, replace relay.

Relays and Modules > Relays and Modules - Starting and Charging > Starter Relay > Component Information > Testing and Inspection

< PREV PAGE NEXT PAGE >