RAM 2500 Van V8-5.2L Prop VIN 2 (2000)
Fig. 8
2. Remove the screw and bumper located at the seal upper corners (Fig. 8).
3. Start at a lower corner and pull outward on the seal. Separate the seal from the door opening.
4. Remove the seal from the door opening.
5. Remove the residual adhesive from the door opening with a suitable solvent.
6. Clean the door opening with an appropriate cleaning solution.
INSTALLATION
1. Apply adhesive around the edge of the door opening.
2. Position the weatherstrip seal on the door opening.
3. Start at the lower, rear corner of the seal. Move upward around the edge of the door opening. Press the seal against the door opening.
4. Install the screw and bumper at the seal corners.
5. Inspect the fit of the door in the door opening. If not correct, adjust the door so that the seal is not crushed when the door is closed.
