RAM 2500 Van V8-5.2L Prop VIN 2 (2000)
7. Squeeze the latches on the gear selector indicator cable housing retainer and pull the retainer out of the receptacle on the PRNDL adjuster, located
on the right side of the steering column near the shift lever actuator.
8. Guide the gear selector indicator cable out of the PRNDL adjuster through the slot in the receptacle.
9. Disengage the loop end of the gear selector indicator cable from the hook on the shift lever actuator.
10. Remove the gear selector indicator from the instrument panel.
INSTALLATION
1. Position the gear selector indicator into the instrument panel.
2. Engage the loop end of the gear selector indicator cable onto the hook on the shift lever actuator.
3. Guide the gear selector indicator cable through the slot in the receptacle of the PRNDL adjuster.
4. Engage the gear selector indicator cable housing retainer in the receptacle on the PRNDL adjuster, located on the right side of the steering column
near the shift lever actuator.
5. Position the gear selector indicator mechanism onto the cluster housing.
6. Install and tighten the two screws that secure the gear selector indicator mechanism to the rear of the instrument cluster housing. Tighten the
screws to 2.2 Nm (20 in. lbs.).
7. Install the instrument cluster into the instrument panel.
8. Check the gear selector indicator for proper calibration. If adjustment is needed, refer to Steering Column for the gear selector indicator cable
(PRNDL) adjustment procedure.
9. Install the knee blocker onto the instrument panel.
10. Reconnect the battery negative cable.
