RAM 2500 Van V8-5.9L VIN Z LDC (2000)
Note: When the ignition switch is turned to OFF, the fuel gage, voltmeter, oil pressure and temperature gages may not show accurate readings.
When the engine is not running, turn the ignition switch to ON to obtain accurate readings.
19. Cruise Indicator Light
This indicator lights when the electronic speed control system is turned ON.
20. Brake Warning Light
This light will glow when the ignition key is turned to the ON position and will remain on for a few seconds. If the light stays on longer, it may
be an indication that the parking brake has not been released. If the light remains ON when the parking brake is OFF, it indicates a possible
brake hydraulic system malfunction. In that case, the light will remain ON until the cause is corrected. This light also illuminates when the
ABS warning light has failed and there is an ABS fault.
WARNING: IF BRAKE FAILURE IS INDICATED, IMMEDIATE REPAIR IS NECESSARY.
CONTINUED OPERATION OF THE VEHICLE IN THIS CONDITION IS DANGEROUS.
21. Transmission Oil Temperature Warning Light
This light indicates that there is excessive transmission fluid temperature that might occur with severe usage such as trailer towing or snow
plowing (if applicable).
If this light comes ON, stop the vehicle and run the engine at idle or faster, with the transmission in NEUTRAL, until the light goes OFF.
22. Trip Odometer Reset Button
Press this button to toggle between the odometer and the trip odometer display.
When in trip odometer mode, holding the button in resets the trip odometer reading.
23. Trip Odometer/Vehicle Odometer
The odometer shows the total distance the vehicle has been driven.
U.S. federal regulations require that upon transfer of vehicle ownership, the seller certify to the purchaser the correct mileage that the vehicle
has been driven. Therefore, if the odometer reading is changed during repair or replacement, be sure to keep a record of the reading before and
after the service so that the correct mileage can be determined.
The trip odometer shows individual trip mileage.
To toggle between the odometer and the trip odometer, press the Odometer/Trip Odometer Button.
