RAM 2500 Van V8-5.9L VIN Z LDC (2000)
5. The sending unit is retained to pump module with a small lock tab and notch (Fig. 26). Carefully push lock tab to the side and away from notch
while sliding sending unit downward on tracks for removal. Note wire routing while removing unit from module.
INSTALLATION
1. Position sending unit into tracks. Note wire routing.
2. Push unit on tracks until lock tab snaps into notch.
3. Connect 2 sending unit wires into 4-way connector and install locking collar.
4. Connect 4-way electrical connector to module.
5. Install fuel pump module. Refer to Fuel Pump Module Removal/installation.
6. Install fuel tank. Refer to Fuel Tank Removal/ Installation.
