RAM 3500 Truck 2WD L6-5.9L DSL Turbo (2008)
3. Install the valve body check balls into their proper locations.
4. Position the separator and transfer plate onto the valve body.
5. Install the screws to hold the transfer plate to the valve body. Tighten the screws to 6 Nm (50 in. lbs.).
6. Install the accumulator piston seal rings onto each accumulator piston.
7. Install the accumulator pistons (1, 6-9) and springs into the valve body in the location from which they were removed. Note that all accumulators
except the overdrive have two springs. The overdrive accumulator piston (6) has only one spring.
8. Install the Low / Reverse shuttle valve, plug, and retainer (2) into the valve body housing.
9. Position the accumulator cover onto the valve body.
10. Install the screws to hold the accumulator cover onto the valve body. Tighten the screws to 7 Nm (60 in. lbs.).
11. Install the manual valve (4).