RAM 3500 Truck 2WD L6-5.9L DSL Turbo (2008)
1. Disconnect wires from governor pressure sensor and solenoid.
2. Remove screws attaching governor body and retainer plate to transfer plate.
3. Remove retainer plate, governor body and gasket from transfer plate.
4. Remove governor pressure sensor from governor body.
5. Remove governor pressure solenoid by pulling it straight out of bore in governor body. Remove and discard solenoid O-rings if worn, cut, or torn.
6. Remove small shoulder bolt that secures solenoid harness case connector (1) to 3-4 accumulator housing (2). Retain shoulder bolt. Either tape it to
harness or thread it back into accumulator housing after connector removal.
7. Unhook overdrive/converter solenoid harness (1) from 3-4 accumulator cover plate (2).
8. Turn valve body over and remove screws that attach overdrive/converter solenoid assembly (1) to valve body.