RAM 3500 Truck 2WD L6-5.9L DSL Turbo VIN 7 (2002)
13.
Select "Update Controller Software".
14.
Monitor the "Status" window on MDS2 and follow the instructions.
15.
Follow the instructions on the DRBIII(R) to complete the calibration download process.
16.
For 2003 and later modules, determine if the vehicle is equipped with a SKIM (Security Key Immobilizer Module) module.
a.
If the vehicle is equipped with SKIM, the DRBIII(R) must be used to transfer the VIN and Security Key from the SKIM to the ECM. This is
accomplished by selecting "Cummins ECM Replaced" under the "Miscellaneous" section of the "SKIM" menu.
b.
If the vehicle is not equipped with SKIM, the VIN must be manually programmed by selecting "CM845 Check VIN" under the
"Miscellaneous" section of the "Cummins Controller (ECM/ENGINE)" menu.**
NOTE:
ALL OTHER NORMAL REPROGRAMMING (FLASH) PROCEDURES, AND **AFFIXING** SOFTWARE UPDATE AND MODIFICATION
LABELS, MUST STILL BE FOLLOWED WHEN INITIALLY PROGRAMMING THESE MODULES.
There are three (3) part numbers available for order, based on Model Year of vehicle.
POLICY:
Information Only
