RAM 3500 Truck 2WD V10-8.0L VIN W MDC (1999)
Wiper Switch: Service and Repair
REMOVAL
WARNING: ON VEHICLES EQUIPPED WITH AIRBAGS, REFER TO AIR BAGS AND SEAT BELTS/AIR BAGS BEFORE
ATTEMPTING ANY STEERING WHEEL, STEERING COLUMN, OR INSTRUMENT PANEL COMPONENT DIAGNOSIS OR
SERVICE. FAILURE TO TAKE THE PROPER PRECAUTIONS COULD RESULT IN ACCIDENTAL AIRBAG DEPLOYMENT AND
POSSIBLE PERSONAL INJURY.
1. Disconnect and isolate the battery negative cable.
2. If the vehicle is so equipped remove the tilt steering column lever.
3. Remove both the upper and lower shrouds from the steering column.
4. Remove the lower fixed column shroud.
Multifunction Switch
5. Move the upper fixed column shroud far enough to access the rear of the multi-function switch.
6. Remove the tamper proof mounting screws (a Snap On tamper proof torx bit TTXR20B2 or equivalent is required) that secure the multi-function
switch to the steering column.