RAM 3500 Truck 2WD V8-5.7L (2008)
EGR Temperature Sensor: Service and Repair
Installation
Installation-Cab/Chassis Models
INSTALLATION-CAB/CHASSIS MODELS
The EGR Temperature Sensor (1) is located on the EGR crossover tube (6) near the EGR valve.
1. Clean EGR crossover tube at sensor mounting point.
2. Check condition of the sensors metal gasket and replace if necessary.
3. Install sensor (1) to EGR tube (6). Tighten to 18 Nm (13 ft. lbs.).
4. Connect electrical connector (2) to sensor.
Installation-Pick Up Models
INSTALLATION-PICK UP MODELS
The EGR Temperature Sensor (1) is located on the intake manifold, below, and to the rear of the EGR valve (5).