RAM 3500 Truck 2WD V8-5.7L (2008)
Hood Sensor/Switch (For Alarm): Service and Repair
Hood Ajar Switch - Removal
SWITCH
1. Unlatch and open the hood.
2. Disconnect and isolate the battery negative cable.
3. From the top of the mounting bracket (3) on the right front load beam (6), squeeze the two hood ajar switch (2) latch tabs together and pull the
switch upward.
4. Pull the hood ajar switch up through the hole in the mounting bracket far enough to access and disconnect the jumper wire harness connector (5)
from the switch connector receptacle.
5. Remove the hood ajar switch from the mounting bracket.