RAM 3500 Truck 2WD V8-5.7L (2008)
Alternator: Testing and Inspection
Diagnosis and Testing - Charging System
DIAGNOSIS AND TESTING - CHARGING SYSTEM
The following procedures may be used to diagnose the charging system if:
-
the check gauges lamp (if equipped) is illuminated with the engine running
-
the voltmeter (if equipped) does not register properly
-
an undercharged or overcharged battery condition occurs.
Remember that an undercharged battery is often caused by:
-
accessories being left on with the engine not running
-
a faulty or improperly adjusted switch that allows a lamp to stay on.
INSPECTION
The PCM (Powertrain Control Module), or ECM (Diesel) monitors critical input and output circuits of the charging system, making sure they are
operational. A Diagnostic Trouble Code (DTC) is assigned to each input and output circuit monitored by the On-Board Diagnostic (OBD) system. Some
charging system circuits are checked continuously, and some are checked only under certain conditions.
Refer to Diagnostic Trouble Codes in; Powertrain Control Module; Electronic Control Modules for more DTC information.
To perform a complete test of the charging system, use a diagnostic scan tool. Perform the following inspections before attaching the scan tool.
1. Inspect the battery condition.
2. Inspect condition of battery cable terminals, battery posts, connections at engine block, starter solenoid and relay. They should be clean and tight.
Repair as required.
3. Inspect all fuses in both the fuseblock and Power Distribution Center (PDC) for tightness in receptacles. They should be properly installed and
tight. Repair or replace as required.
4. Inspect generator mounting bolts for tightness. Replace or tighten bolts if required.
5. Inspect generator drive belt condition and tension. Tighten or replace belt as required.
6. Inspect automatic belt tensioner (if equipped).
7. Inspect generator electrical connections at generator field, battery output, and ground terminal (if equipped). Also check generator ground wire
connection at engine (if equipped). They should all be clean and tight. Repair as required.
