RAM 3500 Truck 2WD V8-5.7L (2008)
6. Remove the lower ball joint nut. Separate the ball joint from the knuckle with puller 8677 and remove the knuckle.
7. Remove the hub/bearing from the steering knuckle See: Wheel Bearing/Service and Repair/Front Hub / Bearing - Removal .
2500 & 3500 - 4WD - Link/Coil
2500 & 3500 - 4WD
1. Remove the hub bearing See: Wheel Bearing/Service and Repair/Front Hub / Bearing - Removal .
2. Remove tie-rod or drag link end from the steering knuckle arm.
3. Remove the wheel speed sensor. See: Brakes and Traction Control/Antilock Brakes / Traction Control Systems/Wheel Speed Sensor/Service and
Repair/Front Wheel Speed Sensor - Removal .
4. Loosen the upper ball stud nut.Do not remove the nut at this time.
5. Remove the lower ball joint nut.
6. Separate the lower ball joint (4) using special tool C-4150A separator (3).
7. Remove the upper ball joint nut.
8. Remove the steering knuckle (2).
4500 & 5500 - Link/Coil
4500 & 5500
1. Remove tie-rod or drag link end from the steering knuckle arm.
2. Remove the disc brake caliper bolts (1) and the disc brake caliper (2).