RAM 3500 Truck 2WD V8-5.7L (2008)
Washer Fluid Level Switch: Service and Repair
Removal
Diesel Engine
DIESEL ENGINE
NOTE: The washer fluid level switch can be removed from the washer reservoir without removing the reservoir from the vehicle.
1. Disconnect and isolate the battery negative cable.
2. Disconnect the washer hose (4) from the barbed outlet nipple of the washer pump/motor unit (3) and allow the washer fluid to drain into a clean
container for reuse.
3. Disconnect the left headlamp and dash wire harness (1) connector for the washer fluid level switch (5) from the switch connector receptacle.
4. Using a trim stick or another suitable wide flat-bladed tool, gently pry the barbed nipple of the washer fluid level switch out of the rubber grommet
seal in the washer reservoir sump (2). Care must be taken not to damage the reservoir.
5. Remove the switch from the reservoir.
6. Remove the rubber grommet seal from the mounting hole in the washer reservoir and discard.
Gasoline Engine
GASOLINE ENGINE
NOTE: The washer fluid level switch can be removed from the washer reservoir without removing the reservoir from the vehicle.
1. Disconnect and isolate the battery negative cable.
2. Disconnect the washer hose (1) from the barbed outlet nipple of the washer pump/motor unit (5) and allow the washer fluid to drain into a clean
container for reuse.
3. Disconnect the right headlamp and dash wire harness (4) connector for the washer fluid level switch (3) from the switch connector receptacle.
4. Using a trim stick or another suitable wide flat-bladed tool, gently pry the barbed nipple of the washer fluid level switch out of the rubber grommet
seal in the washer reservoir sump (2). Care must be taken not to damage the reservoir.