RAM 3500 Truck 2WD V8-5.9L VIN 5 HDC (2000)
Radiator: Service and Repair
Removal and Installation
REMOVAL
1. Disconnect battery negative cables.
WARNING: DO NOT REMOVE THE CYLINDER BLOCK DRAIN PLUGS OR LOOSEN THE RADIATOR DRAINCOCK WITH
THE SYSTEM HOT AND UNDER PRESSURE. SERIOUS BURNS FROM COOLANT CAN OCCUR.
2. Drain the cooling system.
WARNING: CONSTANT TENSION HOSE CLAMPS ARE USED ON MOST COOLING SYSTEM HOSES. WHEN REMOVING OR
INSTALLING, USE ONLY TOOLS DESIGNED FOR SERVICING THIS TYPE OF CLAMP, SUCH AS SPECIAL CLAMP TOOL
(NUMBER 6094). SNAP-ON CLAMP TOOL (NUMBER HPC-20) MAY BE USED FOR LARGER CLAMPS. ALWAYS WEAR
SAFETY GLASSES WHEN SERVICING CONSTANT TENSION CLAMPS.
CAUTION: A number or letter is stamped into the tongue of constant tension clamps. If replacement is necessary, use only an original equipment
clamp with a matching number or letter.
3. Remove hose clamps and hoses from radiator.
4. Remove coolant reserve/overflow tank hose from radiator filler neck nipple.
5. Remove the coolant reserve/overflow tank from the fan shroud (pull straight up). The tank slips into T-slots on the fan shroud.
6. Disconnect electrical connectors at windshield washer reservoir tank and remove tank. Refer to Wiper and Washer Systems for procedures.
